coffee forum, 咖啡討論區, 咖啡購買區, fresh coffee beans and tea house 首頁 coffee forum, 咖啡討論區, 咖啡購買區, fresh coffee beans and tea house
各種咖啡問題, 分享, 討論咖啡心得
 
 常見問題常見問題   搜尋搜尋   會員列表會員列表   會員群組會員群組   會員註冊會員註冊 
 個人資料個人資料   登入檢查您的私人訊息登入檢查您的私人訊息   登入登入 

Hario陶瓷手搖磨豆機

 
發表新主題   回覆主題    coffee forum, 咖啡討論區, 咖啡購買區, fresh coffee beans and tea house 首頁 -> 磨豆機
上一篇主題 :: 下一篇主題  
發表人 內容
Kennethsze



註冊時間: 2009-03-11
文章: 78

發表發表於: 星期三 三月 18, 2009 4:53 pm    文章主題: Hario陶瓷手搖磨豆機 引言回覆

請問如果用來沖espresso,有什麼要注意?刻度大約多少?還是MSC2比較好?
回頂端
檢視會員個人資料 發送私人訊息
prettie



註冊時間: 2009-01-30
文章: 44

發表發表於: 星期四 三月 19, 2009 12:29 am    文章主題: 引言回覆

好架! Rolling Eyes
回頂端
檢視會員個人資料 發送私人訊息
LittleCup



註冊時間: 2009-01-30
文章: 106
來自: Hong Kong

發表發表於: 星期四 三月 19, 2009 8:16 am    文章主題: Re: Hario陶瓷手搖磨豆機 引言回覆

Kennethsze 寫到:
請問如果用來沖espresso,有什麼要注意?刻度大約多少?還是MSC2比較好?

You may do some trial testings on your own grinder, as the setting may vary from beans to beans.

I have HARIO MSC2, and I use 3 or 4 for espresso.
回頂端
檢視會員個人資料 發送私人訊息
Kennethsze



註冊時間: 2009-03-11
文章: 78

發表發表於: 星期四 三月 19, 2009 10:44 am    文章主題: Re: Hario陶瓷手搖磨豆機 引言回覆

LittleCup 寫到:
Kennethsze 寫到:
請問如果用來沖espresso,有什麼要注意?刻度大約多少?還是MSC2比較好?

You may do some trial testings on your own grinder, as the setting may vary from beans to beans.

I have HARIO MSC2, and I use 3 or 4 for espresso.


手搖grinder是否可以磨到和電動磨出來的一樣幼呢?
回頂端
檢視會員個人資料 發送私人訊息
LittleCup



註冊時間: 2009-01-30
文章: 106
來自: Hong Kong

發表發表於: 星期四 三月 19, 2009 2:19 pm    文章主題: Re: Hario陶瓷手搖磨豆機 引言回覆

Kennethsze 寫到:

手搖grinder是否可以磨到和電動磨出來的一樣幼呢?

You may say 手搖grinder can produce very fine grinds, even up to the point it's too fine that no coffee can be extracted from the espresso machine. For example, my hand-held grinder when set to 2, no coffee can be extracted.

For the espresso produced, a good grinding machine can produce so much better espresso than a hand-held grinder. It is mainly because a grinder machine can produce much more "even" grinds, and this is a key point of getting good espresso.
回頂端
檢視會員個人資料 發送私人訊息
LittleCup



註冊時間: 2009-01-30
文章: 106
來自: Hong Kong

發表發表於: 星期四 三月 19, 2009 2:20 pm    文章主題: Re: Hario陶瓷手搖磨豆機 引言回覆

Kennethsze 寫到:

手搖grinder是否可以磨到和電動磨出來的一樣幼呢?

You may say 手搖grinder can produce very fine grinds, even up to the point it's too fine that no coffee can be extracted from the espresso machine. For example, my hand-held grinder when set to 2, no coffee can be extracted.

For the espresso produced, a good grinding machine can produce so much better espresso than a hand-held grinder. It is mainly because a grinder machine can produce much more "even" grinds, and this is a key point of getting good espresso.
回頂端
檢視會員個人資料 發送私人訊息
Kennethsze



註冊時間: 2009-03-11
文章: 78

發表發表於: 星期四 三月 19, 2009 5:37 pm    文章主題: 引言回覆

Thanks LittleCup is so helpful to me!
Since I'm still a student in Academy,I have no budget for grinder machine(of course good one),also a spacing problem in my flat too...May I use a metal net(filter) to eliminate the uneven grinds and make me still use hand-held grinder for lower cost?
Is that good enough?
http://freshcoffeentea.no-ip.info/store/index.php?main_page=product_info&cPath=67&products_id=469

Thanks once again!!!!!! Smile
回頂端
檢視會員個人資料 發送私人訊息
LittleCup



註冊時間: 2009-01-30
文章: 106
來自: Hong Kong

發表發表於: 星期四 三月 19, 2009 5:49 pm    文章主題: 引言回覆

Kennethsze 寫到:
Thanks LittleCup is so helpful to me!
Since I'm still a student in Academy,I have no budget for grinder machine(of course good one),also a spacing problem in my flat too...May I use a metal net(filter) to eliminate the uneven grinds and make me still use hand-held grinder for lower cost?
Is that good enough?
http://freshcoffeentea.no-ip.info/store/index.php?main_page=product_info&cPath=67&products_id=469

Thanks once again!!!!!! Smile

You're welcome Kenneth.

I don't think a metal net will help, because for espresso we need fine grinds, but not too fine. Imagine if two small grains of coffee can pass through the metal net, but one is smaller than the other by 60%, we'll have 2 different sized grains of coffee for brewing, which will produce very different tastes.

If you have a tight budget, it's not too bad to get start with a hand-held grinder, and then upgrade to a grinding machine some time later if budget and space allow.
回頂端
檢視會員個人資料 發送私人訊息
LittleCup



註冊時間: 2009-01-30
文章: 106
來自: Hong Kong

發表發表於: 星期四 三月 19, 2009 5:50 pm    文章主題: 引言回覆

Kennethsze 寫到:
Thanks LittleCup is so helpful to me!
Since I'm still a student in Academy,I have no budget for grinder machine(of course good one),also a spacing problem in my flat too...May I use a metal net(filter) to eliminate the uneven grinds and make me still use hand-held grinder for lower cost?
Is that good enough?
http://freshcoffeentea.no-ip.info/store/index.php?main_page=product_info&cPath=67&products_id=469

Thanks once again!!!!!! Smile

You're welcome Kenneth.

I don't think a metal net will help, because for espresso we need fine grinds, but not too fine. Imagine if two small grains of coffee can pass through the metal net, but one is smaller than the other by 60%, we'll have 2 different sized grains of coffee for brewing, which will produce very different tastes.

If you have a tight budget, it's not too bad to get start with a hand-held grinder, and then upgrade to a grinding machine some time later if budget and space allow.
回頂端
檢視會員個人資料 發送私人訊息
從之前的文章開始顯示:   
發表新主題   回覆主題    coffee forum, 咖啡討論區, 咖啡購買區, fresh coffee beans and tea house 首頁 -> 磨豆機 所有的時間均為 台灣時間 (GMT + 8 小時)
1頁(共1頁)

 
前往:  
無法 在這個版面發表文章
無法 在這個版面回覆文章
無法 在這個版面編輯文章
無法 在這個版面刪除文章
無法 在這個版面進行投票


Powered by phpBB © 2001, 2005 phpBB Group
正體中文語系由 phpbb-tw 維護製作